Precautions
Hydrostatic pressure test
During our decoration, after the completion of welding pipes,we need inspect the quality of pipes, that is we often say the pressure test. The construction of pipes belongs to hidden works in the decoration. Once hidden engineering problems appear, the consequences is incalculable. If the pipe is buried in the ground or floor tiles, the cost of reconstruction will be quite large.
1. Pipes installed, the appearance check is qualified, then the pressure test can be carried out;
2. hot melt or fused connection pipe, the hydrostatic test after 24 hours of the connection;
3. Medium is clean water at room temperature. When in a large system, it can be layered, parted to test the pressure.
Water pressure / method:
1. The hot and cold water connected together by hose. Then hot and cold water forms a ring, pressure testing device connected to any outlet,the pressure pointer is 0. When all the water pipelines installed, the the pressure test could begin. To block all of the plugs and close the water inlet valve manifold before the test.
2. When we do the test, shake the jack lever until the gauge pointer around 0.9-1.0, it is also said that the present pressure is three times than the normal water pressure.
3.Keep this pressure value for a certain time, Different time ,the water load time is different, PPR, aluminum PPR, PPR and other steel-plastic pipe welding time is 30 minutes. Aluminum pipe, that's also the galvanized pips, it needs 4 hours.
PPR pipeline construction safety:
1.PPR pipe cross resistance to ultraviolet radiation, not suitable for outdoor surface mounted installation. If they really need, you need to take shielding measures.
2. PPR pipe's low temperature impact resistance is poor, it should be vent pipes to prevent freezing, swelling
and crack the pipes in winter.
3. Waterproof toilet area, often using asphalt and other petrochemical substances. When it is doing waterproof needs shelter on pipeline protection.
){kind=link}